·The belt´s top surface has a muffling effect, which absorbs vibrations
and impact from materials being transported. At the same time it stops
goods from sliding.
·Depending on the material being transported, it is possible to transport
at a slopping angle of 25º to 35º.
·Cut edge.
·Belts with no bottom cover reduce the friction risk. These are recommended
for top table or flat top panel systems.
RESISTANCE TO SEPARATION
Between cover and plies 8 N/mm
Between plies 10 N/mm
WIDTH
Maximum width for the white belts is 1200 mm.
ELONGATION UNDER STANDARD LOAD
Maximum enlargement under work charge is lower than 1.5%
COVERING QUALITIES
We manufacture our rough top in the same qualities as the other belts, accoring to customer requirements.